Check Point Software Technologies 2205 Bedienungsanleitung PDF herunterladen (Seite 13)

Configuring Check Point 2200 Appliance

Check Point 2200 Appliance Getting Started Guide | 13

 This Gateway uses a dynamically assigned IP

Web/SSH and GUI Clients Configuration

Define the clients that are allowed to connect to the appliance using a web browser or SSH client. These

clients can manage the appliance using a web or SSH connection.

You can define a Host according to Hostname or IP address. Enter a comma-separated list of IP

addresses from which you manage the appliance. Enter Any to manage the appliance from anywhere.

Note - Do not use the Any value for security reasons.

After you complete the First Time Configuration Wizard, more options are available using the WebUI menu.

SIC Setup

Configure the SIC (Secure Internal Communication) settings for a Centrally Managed appliance. Enter a

SIC Activation Key. The same key is used by the gateway object in SmartDashboard.

Summary

The Summary page opens.

Click Finish to complete the First-Time Configuration Wizard. You can log in to the appliance after some

minutes.

Note - You should back up the system configuration. The Backup and

Restore window can be accessed from the WebUI interface,

Appliance > Backup and Restore.

Creating the Network Object

Configure the Check Point 2200 Appliance as a gateway object in the Security Management Server

database.

To create the network object in SmartDashboard:

1. Launch SmartDashboard.

2. Configure a new gateway object for the appliance.

3. Enter the IP address for the appliance.

4. For a centrally managed installation, establish Secure Internal Communication (SIC) using the activation

key entered in the First Time Configuration Wizard.

5. Configure the topology.

6. Install the security policy.

Advanced Configuration

Advanced configuration on SecurePlatform

Advanced configuration on SecurePlatform can be done using the sysconfig menu which can be

accessed using the command line interface only. For example, configuring the appliance to be a DHCP

server.

Note - The sysconfig menu is only available after running the First

Time Configuration Wizard in the WebUI.

CLI access can be obtained by console connection or through SSH.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20 21

Keine Kommentare

Check Point Software Technologies 2205 Bedienungsanleitung Seite 13